Online audio equalizer

Three bands, low, mid and high, each with up to 12 dB of boost or cut. Fix a muddy recording, tame harsh highs or add warmth, and hear every change as you make it.

Loading the tool…

How to EQ an audio file

  1. Drop a song or recording here, or press Use a demo loop.
  2. Press Preview. Every band starts flat, at 0 dB.
  3. Find the problem first: listen for boom, honk or harshness, then move the matching band down a few decibels.
  4. Boost gently where something is missing. Two or three decibels is often enough.
  5. If your cuts made the file quieter, raise Volume to match, then press Download WAV.

The three bands

BandFilterRangeWhat it affects
Low (bass)Low shelf at 110 Hz-12 to +12 dBKick drums, bass lines, rumble and boom
MidBell centered on 1 kHz, about one and a half octaves wide-12 to +12 dBThe body of voices and instruments: honk, nasal tone, presence
High (treble)High shelf at 6 kHz-12 to +12 dBCymbals, breath, sibilance, air and hiss

A shelf raises or lowers everything beyond its frequency, like tilting one end of the spectrum. A bell works on a region around its center and leaves both ends alone. Volume raises the overall level after the bands, and a limiter at the end keeps peaks below the clipping point.

Quick fixes

If it soundsTry
Muddy or boomyLow -2 to -4 dB
Thin or tinnyLow +3 to +6 dB
Nasal, honky, like a telephoneMid -2 to -4 dB
Voice buried, hard to followMid +2 to +3 dB
Harsh, hissy or full of sharp "s" soundsHigh -2 to -4 dB
Dull or muffledHigh +2 to +4 dB

EQ habits that work

  • Cut before you boost. Removing what is wrong usually sounds cleaner than piling on what seems missing, and it leaves room before the limiter.
  • Make small moves. Most fixes need 2 to 4 dB. If you need 10 dB or more, the recording may be the problem rather than the tone.
  • Judge tone, not loudness. A louder version almost always sounds better at first, which tricks the ear. After a boost, flip the band back to 0 and forward again a few times, and listen for the change in tone rather than the change in level.
  • Check on another system. A setting that sounds right on headphones may be boomy on a car stereo or thin on a phone. Test on whatever your listeners will use.

Need more low end than 12 dB? The bass booster goes to +18 dB. Want the file louder overall without changing its tone? Use the volume booster.

Questions

What is the best EQ setting for music?

There isn't one. The right setting depends on the recording and on what you play it through. Start flat, fix the one thing that bothers you most, and stop when it sounds natural. Settings copied from someone else's song rarely suit yours.

Can an equalizer remove vocals or background noise?

No. EQ changes the balance of broad frequency ranges. Voices, instruments and most noise overlap in frequency, so cutting one band also cuts part of everything else. It can soften a rumble or a hiss, but it can't separate sounds.

When should I use the bass booster instead?

When you want more low end than the equalizer's +12 dB. The bass booster goes to +18 dB below about 110 Hz but can't cut anything, while the equalizer shapes the whole range.

Does EQ reduce the audio quality?

Gentle EQ is effectively transparent. Large boosts can bring up hidden noise and push the limiter, so keep big moves for problems you can clearly hear.

Is my audio sent anywhere?

No. Every filter runs in your browser and the equalized WAV is written on your device.